Re: How do you model Elliot OR Buda switch stands?

Posted by Jeff Young on Jul 27, 2015; 2:48pm
URL: http://c-sng-discussion-forum.254.s1.nabble.com/How-do-you-model-Elliot-switch-stands-tp2229p3006.html

A bit more data on the Buda:

Chris was on to something I didn't realize: the fronts of the legs are vertical; all the slope is in the back of the legs.  

There is a radius fillet at the bottom of the legs (which are cast integrally with the base).  Immediately above that the legs are 4-1/4" thick.  

There's no radius at the tops (the top plate is a separate piece which is bolted to the legs).  The legs are 3-1/4" thick at the top.  

The internal web is 1-1/2" back from the front surface of the legs all the way up.

The base is 16-1/2" wide at the center of the button.  (Or at least it would be if there wasn't a crescent cut out of the back.  The crescent is 2-1/4" deep by 10" wide.)

The center of the web of the legs is 5" from the straight part of the back; 11-1/2" from the center of the front button.

Cheers,
Jeff.