Re: C&S RPO 11: couplers
Posted by drgwcs on Feb 18, 2025; 5:03am
URL: http://c-sng-discussion-forum.254.s1.nabble.com/C-S-RPO-11-Linn-Moedinger-s-Shapeways-Print-in-Sn3-and-Hon3-tp12427p20506.html
I am reworking a Labelle HOn3 RPO to be somewhat of a 13 (although will be a off) does anyone have a suggestion for a brake wheel to use? Since Keith here used an On3 brakewheel for S- I figure that an S one will be about right for HO. San Juan/ Grandt did not have anything, neither did Tichy. Glanced at PBL but no photos. Any suggestions? (also did someone know the prototype diameter?
URL: http://c-sng-discussion-forum.254.s1.nabble.com/C-S-RPO-11-Linn-Moedinger-s-Shapeways-Print-in-Sn3-and-Hon3-tp12427p20506.html
Resurrecting a bit of an old thread here.
Jim Courtney suggested some 16" On3 MacLeod Western brake wheels would scale out about right for the RPO (I am partial to the large wheels on the C&S head end cars). I ordered some, and they will work out great.
While visiting Caboose, I also purchased a Soundcar, keep-alive and speaker. Now all I am lacking is the needle beam/queenpost bit.
I am reworking a Labelle HOn3 RPO to be somewhat of a 13 (although will be a off) does anyone have a suggestion for a brake wheel to use? Since Keith here used an On3 brakewheel for S- I figure that an S one will be about right for HO. San Juan/ Grandt did not have anything, neither did Tichy. Glanced at PBL but no photos. Any suggestions? (also did someone know the prototype diameter?
Jim Curran
| Free forum by Nabble | Edit this page |