Re: Flanger 015

Posted by Keith Hayes on
URL: http://c-sng-discussion-forum.254.s1.nabble.com/Flanger-015-tp19711p20149.html

The Colorado Model Railroad Museum hosted an RPM near the Museum in Greeley yesterday. I packed up some models to show off some Sn3 models in a room of mostly HO and some N, O and On3 models.




And who doesn't like this vest-pocket turbine?!?

The RPM was a distraction as I prepared a base to show some models on. I dislike traveling with models and sure enough the coal sustained some damage. I fot this repaired today and set to bending the air pipes for the flanger.

The brass wire was tempered with a lighter and the bends were referenced on the photos and model, using a Sharpie to mark the bends. It was a measure twice,  look at the photo 3 times and gently hold it in place just before bending sort of operation.  I am glad this is done.  The pipes are in the paint shop now. They need to go on before the handrails and blade signal.

It was great to see a couple readers at the RPM!