Re: Type C/UP trucks
Posted by Michael York on Jun 16, 2021; 5:47pm
URL: http://c-sng-discussion-forum.254.s1.nabble.com/Type-C-UP-trucks-tp15497p16736.html
Here are the holes for mounting the brake beams
Mine arrived yesterday. I left them outside for a couple hours to be assured that the acrylic has fully cured, but I haven't cleaned them yet. All of the prints look really nice.
The On3 version is free rolling. Both materials printed, but the detail plastic definitely looks better. The journal lettering is legible. It was a bit of a tighter fit to slide the axle into place.
The HOn3 version isn't free rolling. I'm not sure if that is due to the wax.
My 2-1 seating for Combine #20 shall get a new thread...I'm excited about those.
Michael
URL: http://c-sng-discussion-forum.254.s1.nabble.com/Type-C-UP-trucks-tp15497p16736.html
Here are the holes for mounting the brake beams
Mine arrived yesterday. I left them outside for a couple hours to be assured that the acrylic has fully cured, but I haven't cleaned them yet. All of the prints look really nice.
The On3 version is free rolling. Both materials printed, but the detail plastic definitely looks better. The journal lettering is legible. It was a bit of a tighter fit to slide the axle into place.
The HOn3 version isn't free rolling. I'm not sure if that is due to the wax.
My 2-1 seating for Combine #20 shall get a new thread...I'm excited about those.
Michael
| Free forum by Nabble | Edit this page |